The "do" Command allows you to run "show"
commands while in config mode so that you don't have to exit back to
privileged mode to chech your work when you are configuring a router.
Example:
router(config)#do show interface f0/1
router(config-if)#do show run
Labels
- Cheat Sheets (7)
- Checkpoint (159)
- Cisco (24)
- Commands (5)
- Fortigate (2)
- Frame-Relay (9)
- Linux (3)
- Netscaler (29)
- Netscreen (2)
- Nokia (7)
- UNIX (2)
Live Traffic
The "Do" Command on a Cisco Router
7/02/2011 07:33:00 AM
Posted by MK | Filed Under Cisco | 2 Comments
Comments
Search This Blog
Blog Archive
-
▼
2011
(107)
-
▼
July
(49)
- Clear Cisco Router Configuration Back to Factory D...
- Configuration Archiving on Cisco Routers
- Auto Tuning Buffers on Cisco Router
- Tuning Cisco Router Buffers
- Configure Layer 3 port-channel (EtherChannel) betw...
- IPv6 Quick Facts
- The "Do" Command on a Cisco Router
- Subnet Cheat Sheet
- Linux Cheat Sheet - Command Line
- ScreenOS Cheat Sheet
- Cisco IOS Cheat Sheet
- Network Cheatsheet
- digital signal X
- The speed of...
- frame-relay full mesh
- point-to-point vs. multipoint in frame-relay
- inverse-arp in frame-relay
- static and dynamic mappings in frame-relay
- frame-relay map ip dlci broadcast
- debugging frame-relay
- Frame-Relay and traffic shaping (FRTS)
- A simple explanation FECN / BECN
- different kinds of frame-relay connections, dynami...
- Set Cisco Stack Master Placement in Switch Stack
- Enable Stateful Switchover (SSO) on Cisco Switch S...
- Virtual Trunk Protocol (VTP) Cisco Switch Configur...
- Rapid Per-VLAN Spanning-Tree (PVST+) Cisco Switch ...
- Unidirectional Link Detection (UDLD) Cisco Switch ...
- Configuring Cisco EtherChannel Load Balancing Method
- Cisco Best Practice - Turn off http, telnet and en...
- You can't set duplex/speed settings of the Fortiga...
- Fortigate firewall demo free access. Also FortiMan...
- Visio stencils for Cisco, Juniper, Fortinet, Check...
- CheckPoint SecureClient Ports
- How to debug a CheckPoint VPN Connection
- Show the name of the installed CheckPoint Policy
- Checklist for adding new interface on a CheckPoint FW
- CheckPoint Failover Commands
- Command to list CheckPoint Installed Products
- How to run a CheckPoint Debug
- List the Top Connections on a CheckPoint Firewall
- Clear CheckPoint NAT and State Table
- CheckPoint Log Buffer Full
- IPSO CLISH Interface Examples
- How to deal with CheckPoint Certificate if it is E...
- How to delete manually a license for Checkpoint
- Troubleshooting Checkpoint VPNS with IKEVIEW
- Display top CPU processes on the router
- Quick tip: Display Interface bandwidth
-
▼
July
(49)
It is very helpfull for everyone, thanks for sharing this information..... Kalyx transcanding connections
It is very helpful for everyone, thanks for sharing this information..... CISCO Firewall