Saturday, July 2, 2011

The "Do" Command on a Cisco Router

The "do" Command allows you to run "show" commands while in config mode so that you don't have to exit back to privileged mode to chech your work when you are configuring a router.

Example:

router(config)#do show interface f0/1

router(config-if)#do show run
at

2 comments:

  1. AnonymousApril 16, 2020 at 9:17 PM

    It is very helpfull for everyone, thanks for sharing this information..... Kalyx transcanding connections

    ReplyDelete
  2. AnonymousMay 4, 2020 at 5:26 AM

    It is very helpful for everyone, thanks for sharing this information..... CISCO Firewall

    ReplyDelete